Crack Repair Under VCT or Laminate Flooring

Use Concrete Mender™ to repair  cracks, joints and curling slabs under VCT or tile floors. The permanent performance and 10 minute cure turns this 2 day job into a one day (or one night) job. Keep business running with minimal down time.

Repairing control or contraction joints under VCT.
Repairing contraction joints under VCT.

For spalled or failed control joints that are reflecting through the tile and the slabs are not curled, clean out the joints with a dust collecting diamond grinder.

Control or contraction joints repaired with 10 Minute Concrete Mender™ under VCT.
Control or contraction joints repaired with 10 Minute Concrete Mender™ under VCT.

Repair the control joints with Roadware 10 Minute Concrete Mender™, grind the surface flush and replace the tile.

 

For curled and buckled slabs, a major retailer specifies this heavy duty solution. This is the ultimate fix it once and fix it forever repair.

crack-repair-concrete-mender-vct-flooring_03

Step 1: Remove VCT, Ceramic, or vinyl floor coverings.

 

crack-repair-concrete-mender-vct-flooring_06

Step 2: Saw cut parallel lines to the crack at a depth of no less than 1.5 inches. Ideally 30% of the slab depth.

 

crack-repair-concrete-mender-vct-flooring_08

Step 3: Chip out the concrete between the saw cuts. Clean the surface well with a wire brush and vacuum.

 

crack-repair-concrete-mender-vct-flooring_10

Step 4: Add Roadware 10 Minute Concrete Mender and Sand to the finished grade. Also use Concrete Mender to repair the underlaying crack. See Concrete Mender™ Bulk Application Instructions.

 

crack-repair-concrete-mender-vct-flooring_13

Step 5: Replace the floor treatment and open to store traffic.

 

 

3 thoughts on “Crack Repair Under VCT or Laminate Flooring”

Leave a Reply to Drew Cancel reply

Your email address will not be published. Required fields are marked *